Monday, January 23, 2012

Sleeper to Jacket Refashion

Blooms And Bugs: Sleeper to Jacket refashion tutorial

This post was published as a guest feature at Me Sew Crazy last December. Publishing it here again in case you missed it last time around.



Ever since my daughter started walking her growth has only been vertical. That means clothes that fit well in the waist and body but are a few inches too short. Way too many of them. I found some fleece sleepers that were almost new but were at least two inches short already. Since she needed some jackets for the light California winters, I decided to try and refashion these sleepers into fleece jackets. And what do you know! It was super simple and it worked! Here's how I did it.

Supplies:

1.  Sleeper that fits well in the width but may be too short or too long
2. Fat quarter of coordinating woven fabric

Construction:

1.

 Close the zip up to the top. (This is very important, if you keep the zip open, you may not be able to close it completely after you cut. Don't ask me how I know that. Just keep that thing shut...ok.) Find the length that you think would be good for the jacket. Cut the sleeper horizontally 1 inch above that length. I chose to cut it right above the legs to get the maximum possible length. The finished jacket comes to my daughter's thighs, making it longer than the usual but I like that length. If you want a particular length for the jacket make sure you cut accordingly.

2.


 Pick out the cuffs on the sleeves using a seam ripper. This may take a few minutes so be patient. Usually if the sleeper is shorter in length than it is likely shorter at the sleeves too, I'll show you how to increase the length of sleeves a bit.

3. Measurements

Now measure the circumference of the hemline, lets call it L1. Also measure the circumference of cuffs. Lets call it L2. Now cut a 3 inch wide strip of length L1+(2xL2) + 5 inches. We will use this to finish the hem and cuffs of the coat.

4. Making the 'Bias Tape' for hemline and sleeve cuffs

I'm calling it Bias tape but actually it is cut on grain not on the bias. We can get away with this because we will be using it on the straight edges and not curves. However if you would like to use a bias tape that would work too.

Fold the strip you cut earlier in half along the length and iron.


Now fold one edge quarter inch and iron, this may take a few minutes. You may want to make a crease by hand before ironing to make it easy to iron. Quilting weight cottons retain crease well so they're easier to work with for this project.

Now fold the other raw edge a little less than quarter inch. Folding it lesser will ensure that when we sew this bias tape, it will catch the seam on the inside.
I'll explain more when we get to sewing it.

In the pic above the top edge is folded lesser than the bottom edge.




Here's the finished bias tape.


5. Finishing the hemline



Line up the raw edge that is folded more with the raw hemline of the sleeper ( right sides together). Make sure you leave one inch bias tape unsewn in the beginning. Sew along the hemline. Try to keep the seam on the crease of the fold as shown in the pic above.


When you get close to the starting point ( within 3 inches), measure the tape you will need to finish it and cut half inch longer bias tape than that.

Now line up both the raw ends of bias tape and sew with right sides together. This will ensure a very clean finish.

 Now finish sewing the remaining of the seam along the hemline.



Now fold the bias tape down and fold the part below the center crease inside.


Make sure that the bias tape is folded on the inside with no raw side visible. Since we folded that end lesser, when we fold it on the inside that edge of bias tape will go higher than the edge on the outside. Now sew a seam as close to the bias tape ( but not on) as possible. Go slowly on this seam as it will show on the outside.


The hemline is ready.

6. Adding the cuffs on the sleeves:





The cuffs are made the exact same way as the bias tape at the hemline. The only thing I need to mention is that you could make the cuffs a different length than the hem, so measure the length of existing sleeves and compare with the length you need and adjust the bias tape width accordingly.


So that's our easy refashion - A sleeper to a fleece jacket. Sew easy, sew fun!


Make one, make many! Enjoy!
Pin It

17 comments:

  1. What a great idea! Thanks for sharing it again.

    ReplyDelete
  2. What a really cool idea. Thanks for linking it to the 12 month challenge.

    ReplyDelete
  3. We are in that stag of vertical growth too. I love how you altered this top. Have a fabulous weekend!
    ~Kimberlee, The Spunky Diva

    ReplyDelete
  4. Great refashion! And what cute fabric too!


    Thanks for linking to a Round Tuit!
    Hope you have a fabulous week!
    Jill @ Creating my way to Success
    http://www.jembellish.blogspot.com/

    ReplyDelete
  5. This is such a great idea! My daughter has some clothes that are too short as well. I should look into this.

    ReplyDelete
  6. What a great way to extend the life of kids' clothes. Thanks for sharing at my party!

    ReplyDelete
  7. Perfect idea for repurposing clothes for the kiddos! Thanks so much for sharing at the Tuesday To Do Party!
    Smiles!
    Jami
    www.blackberryvine.blogspot.com

    ReplyDelete
  8. what an awesome idea!

    www.notimefortea.com

    ReplyDelete
  9. that is a great idea! Love it and the fabric too.. :)
    Thanks for linking up!

    ReplyDelete
  10. how cute

    Thanks for linking up to Serenity Saturday Link Party!
    Hope you can join me again tomorrow

    Natasha xx

    www.serenityyou.blogspot.com

    ReplyDelete
  11. This is so cute. I have some of my sons jumpers that I would love to make a jacket out of.

    madebyniki.blogspot.com

    ReplyDelete
  12. So what happens with the bottom of the zip? Does the new hem close across it?

    ReplyDelete
    Replies
    1. I want to know about this, too..is this now an over the head jacket?

      Delete
    2. @dsc, davispigeon: Yes it now becomes an over the head jacket.

      Delete
  13. We Introduce Bomber Jackets In United State With Premium Quality Leather Used In Making Leather Jackets
    Kavinsky Electro Varsity Red And White Jacket
    WILSONS Adventure Bound Leather Bomber Jacket

    ReplyDelete

Leave some sugar :)